CBU Series

SMART DC UPS 36W - 240W

• Smart DC UPS
• Compact size , DIN rail mountable
• Output voltages: 12,24,48VDC
• Simple operation and quick installation
• Double power for high surge loads
• Multistep charger for maximum battery life
• Auto diagnostic features

UPS2410

SMART DC UPS 240W Load 120W Charger

• Input rated voltage 115, 230, 400Vac
• Output: 12, 24Vdc, in case of fault in the main too
• Output In: 0,7A ÷ 10A, in case of fault in the main too
• Signals for “Battery Fault”; “Low Battery”; “Replace Battery”
• Life test function (not on all models)
• Protections against "Short-circuit"; "Over load"; "Over voltage out" and "Reverse battery"
• 2 charging modes: “Boost”; “Trickle”
• Accessories on demand: external temperature probe for voltage compensation; RS232 connection output
• Battery charger independent from the power supply•Small size
• Ambient temperature operation range: -10 to 50°C

SR-U

SMART DC UPS 250W , 500W , 750W

Independent load and battery regulators.
Temperature Compensated battery float voltage.
Battery charge current limiter.
Alarms (relay). PSU OK, Battery System OK.
Battery deep discharge protection - disconnect/reconnect with alarm.
Rapid install / de-install with all connections via Phoenix connector blocks, (for systems <20A).
Wide input voltage window tolerance.
Precise Voltage and Current controls.
Compact and lightweight.
High efficiency - (typically >85%) using switchmode technology.
Self resetting electronic circuit breaker for overload, short circuit or reverse polarity protection.
Conservative design for long life.
Optionally available regular BATTERY CONDITION TESTING
Customisable 'load vs charge' proportions.
19 inch rack mount and wall mount options.
24 month warranty.
Standard battery voltage options: 12V, 24V, 36V , 48V

SNB SERIES

DC UPS 50W - 150W

•  Wide AC input 90 - 264 VAC
• High efficiency, switched mode design.
• Fully isolated output
• Power fail and battery fail alarms
• DC ok and battery ok LEDs
• Isolation diode
• Battery fuse protected
• Overload and OVP protection of rectifier module
• Wall mount enclosure with battery "SNBW"
• AS3260 approved rectifier modules No. CS7067N
• Low volt disconnect - option

BX

DC UPS 200W - 1000W

• Switched mode design
• Output options::12V,24V,36V,48V,60V &108V
• Power levels from 200 to 750 watts
• Constant voltage/constant current operation
• Overvoltage and overload protection
• Power Fail and Battery Low alarm signals
• Temperature compensation charging
• EMC to EN55022 and EN61000
• N+1 redundancy operation
• CE marked to Low Voltage Directive
• AS3260 safety approval:NCS7346N
• EMC approved
• Battery low volt disconnect

GS SERIES

DC UPS 120W

 Robust Design
Compact structure
Temperature compensated charging
User programmable charge Topologies
Fully protected AC & DC operation

SAU40

DC UPS Module

Battery controller for DIN Rail UPS systems
Parallel connection to DC BUS
Suitable for 24V systems up to 40A
Built in battery test function
Battery polarity protection
Relay contact signal output and LED for DC BUS OK, Battery OK and Battery Discharge
Free air convection cooling